SuperCIDing
1. Uninstall ActiveSync
2. Reboot the PC
3. Boot The Phone holding power button and camera button to enter bootloader.
4. Phone Wil Display Serial in Bottom
5. Connect Phone to PC
6. Phone should Display USB instead of Serial in Bottom
7. Go to Hardware tab and See Under USB that Device Exist there
8. start mtty.exe
9. Select All Default and Connect to USB in drop down box
10. run command rtask a : After this Command Phone will not Display any thing
11. run command echo_on : even though nothing is shown to screen
12. run command readCID : in Sprint it will display SPCS_001
13. run command writeCID 00000000 : Set CID Value to 00000000 replaces SPCS_001 in Sprint (This make PPC Radio Security Level to Zero)
14. run command readCID : This will Display the Update CID as 00000000
15. run command rtask c

will need someone else to test this. This was tested using an esn from an active mogul and entering the information on a cloned touch.
1. Change ESN from mogul to touch.
2. Enter mdn and msid via ##msl#.
3. Change all information in M.IP default and M.IP customer to match Mogul.
4. Not needed 
5. Open Qpst Version 2.7 build 215
6.Go to Qpst Start Clients EFS explorer Enter MSL
7.Exit efs explorer
8. now open QXDM version 3.09.19
9. Once in QXDM go to NV ITEMs then to hdr_an_auth_passwd_long ITEM 01192 located in the Data Category.
10.Write down all the hex vales skip the first start with password 0-15
11. Now go to QPST service programming
12.Click read from phone 
13.Then go to M IP Profile
14.click profile 0
15.then go to AAA shared secret and enter the hex values u wrote down do not use 0x00 just 00 and so on
16.now click ok
17.then click write to phone
18.then exit
19.now go to phone and enter ##778#
20.now go to edit 
21.then go to M.IP default profile
22.make sure HA shared secret says secret in lowercase( when i did step #22 my evdo didnt authenticate, i just left it blank)
23.click menu ok then reset